Engineering bite silicone bite safety fit ergonomic design. Material: Stainless steel + aluminum alloy + silica gel + Aviation aluminum. Respirator material: aviation aluminum + silica gel. 13 6 35.2 5.8 cm/5.12.413.92.3in.
Gas capacity: 3.0 CU FT/85 LITERS. 13.4 / 34 cm. Maximum pressure: 3000 PSI/200 BAR/20MPA. Number of surface breaths: about 30 (2.5 LITERS per breath). It can breathe about 57 mouths of air on the surface, and adults can breathe about 21 times under the mouth of water, 7 meters under the water for about 6 minutes!The product contains an inflatable head, which can be directly inflated in a standard diving cylinder and can be fixed on the BCD. The product is portable and independent of the respiratory system. High pressure air pump material: stainless steel. 62 26.2 3.6 cm/24.410.31.4in. Size when pumping: 106.5cm/41.9in.
Step on the opening size: Approx. 3.1cm/1.2in, length: Approx. 65 38.5 10.5 cm/25.615.24.1in. Size of single outer box: Approx. Size of 5PCS in a box: Approx.675441.5cm/26.421.316.3in. 1 High pressure air pump(Accessories: 1 air pipe, 1 connector, 1 spanner, size 14.850.25cm, 2 packages of accessories). High-pressure air pump, in the process of air inflating due to up and down friction, resulting in fever, this phenomenon is normal. The phenomenon of oxygen cylinder respirator can't be inflated: firstly, when oxygen cylinder respirator is delivered, it does not contain gas, secondly, check the high-pressure pump before inflating the high-pressure pump, assemble it according to the instructions, install the gasket rubber ring, tighten the exhaust valve, and then inflate it. This product is different from oxygen pumps such as basketball, volleyball. Effectively, please be patient to inflating for two or three minutes before the pressure gauge will change. It takes three men to inflating about 16 minutes for each oxygen cylinder to fill up. Within 3000PSI, it is within the normal range. Over 3000PSI may burst (please don't inflating too full). Oxygen cylinder head and body should be checked for tightness, good connection and not standing above the oxygen cylinder when inflating. Be careful not to inflate the oxygen cylinder to a certain pressure. Please pay attention to safety. When the pump is finished, please notice that it is dangerous to twist the exhaust valve of the high-pressure pump and suddenly pull out the connecting port between the pump and the oxygen cylinder.
Instead of leaving negative/neutral feedback or opening a dispute. Our listing price includes the value of goods, packaging cost, and export. Please check with your country's. We will reply your message within 48 hours.
If you do not receive our reply within 48 hours, pls. Post a message again because sometimes our message system may block some emails.
If you are satisfied with our service, pls. Our aim is to provide Top Level Customer Service, your recognition will encourage us greatly and serve you better. We strive to keep all our customers satisfy.We will always do our up most to exceed your expectations in customer service, communication and dispatching of your orders. The item "SMACO Oxygen Cylinder Mini Scuba Diving Equipment Air Tank Oxygen Tank Set Kit" is in sale since Thursday, January 31, 2019. This item is in the category "Sporting Goods\SCUBA & Snorkelling\Cylinders & Tanks". The seller is "globeselling100" and is located in Hongkong. This item can be shipped worldwide.