2000W 48V wind generator, hybrid charge controller, mast / tower set IstaBreeze®. Robust wind generator Original iSTA-Breeze i-2000.Due to the production of fiberglass-reinforced plastic, the rotor blades are very durable and stable, and at the same time unusually light. The housing is equipped with cooling fins and is made of high-strength aluminum. The maintenance-free sliding contact (without carbon) guarantees a good flow of current and therefore no twisting of the cable in the mast. Installation in the mast tube using a plug connection.
Required inner diameter of the mast tube: nominal size 37 mm! Further technical data below in the description. This product is used successfully 1000 times worldwide! Product description - charge controller. The pictures visually show the operating status.
Various data show: wind turbine voltage, current, power, solar panel voltage, current, power, battery group voltage, charging current (the main board is equipped with a button battery) In the event of a power failure, the history data can be saved for 30 days. Two sets of control systems: PWM constant voltage system and three-phase dump-load system. The PWM constant voltage control is 120% of the nominal power of the wind turbine. If the PWM capacity is exceeded, the three-phase tipping load starts automatically immediately to ensure safe operation of the entire wind turbine.
When the strong or super strong wind controls PWM to make sure the battery is charged by the wind turbine with constant voltage and current. If the battery is disconnected or damaged, the three-phase tipping load will start automatically to prevent the wind turbine from idling and a runaway accident. The protective function of the battery: reverse polarity protection, shutdown and damage protection. Battery Overcharge Protection: When the battery is full (the battery voltage reaches 125% of the rated voltage), the controller will automatically perform a three-phase drain load to stop charging the battery.
PRODUCT FEATURES - WIND GENERATOR. SIZE 21 x 61 x 41.START WIND SPEED WIND SPEED 2 m / s RATED WIND SPEED 12.5 m / s. MATERIAL Composite (white), carbon (carbon). WEIGHT 650 g (white per repeller) 780 g (carbon per repeller). Nominal power of the wind turbine. Wind turbine voltage, wind turbine power, wind turbine power, solar panel voltage, solar panel power, solar panel power, battery voltage, charging current. 3-phase load voltage of the wind turbine. Solar controller stops charging voltage. The diameter of the mast is 60 mm. The mast can be extended by a maximum of 2 meters! Inner hole, connecting wind generator is 37 mm. 4 meter IstaBreeze TOWER for wind generator i700 to i2000, IstaBreeze It has never been so easy to install a wind generator. With the IstaBreeze Tower it is possible to build a wind generator in a few minutes.
The folding system simplifies the whole process. Only a few screws are loosened during maintenance and the tower can be folded up for maintenance.Dowels and screws for the floor (concrete floor) are still required!! Optional The vibration damper for the wind generators i-500-L-500 and i-700 to i-2000 reduces the transmission of structural noise from the wind generator into the mast and thus possibly into the house. Retrofitting is very easy because the silencer has the same dimensions as the wind generator. It may only be inserted between these and screwed to the mast and the wind generator with suitable screws. The vibration damper is compatible with our original IstaBreeze masts 15 kg and 40 kg.
The total height of the vibration damper is 20 cm, the total diameter of the damper is 13.5 cm. The weight of the damper is 3.7 kg. Features of the vibration damper: Generator bracket / internal dimension: 37 mm pole bracket / external dimension: 37 mm Screws: mounted in rubber (stainless steel V2A). Spring hammer press eyelet press rivet press f.
Eyelets, rivets, tarpaulins, banners, eyelets. Screw press / rivet press (universally applicable). FAST TRADING Hollow riveting tool 6mm, 7mm, 9mm, 12mm, eye press, double single cap. Set FAST TRADING eyelet tool 3/4/5/6/7/10/12 / 17mm, eyelets, eyelet press, tarpaulins. Push button tool, S spring, ring spring, 15 / 12.5 / 10 / 15mm Type 61.
Hole punch 1-17mm to choose from, punch for punching for eyelets etc. Set i-2000W 48V Windsafe wind generator + hybrid charge controller Ista-Breeze. I-2000W 48V Windsafe wind generator Ista-Breeze. Set i-1500W 24V Windsafe wind generator + hybrid charge controller Ista-Breeze. I-1500W 24V Windsafe wind generator Ista-Breeze.Backflow flap Ø DN 50, 75, DN 100, 125, DN 160, backflow stop HT / KG pipes. Set i-1500W 48V wind generator + hybrid charge controller Ista-Breeze. The item "2000W 48V Wind Generator, Hybrid Charge Controller, Mast /Tower Set Ista Breeze" is in sale since Monday, August 17, 2020. This item is in the category "Home, Furniture & DIY\DIY Materials\Electrical Supplies\Alternative Energy Supplies\Wind Power Supplies\Wind Turbines & Kits".bg" and is located in aytos. This item can be shipped worldwide.